Table of Contents
Advertisement
DAI Header (P3)
The DAI connector (
from of a .1" spacing header. When using the header to access the DAI
pins of the processor, ensure that signals, which normally drive the DAI
pins, are disabled. Refer to
more information on how to disable signals already being driven from
elsewhere on the EZ-KIT Lite.
Part Description
26-pin IDC Header (
USB Connector (P4)
The USB connector (
Part Description
Type B USB receptacle (
JTAG Header (P5)
The JTAG header (
lator pod. When an emulator is connected to the JTAG header, the USB
debug interface is disabled.
Pin 3 is missing to provide keying. Pin 3 in the mating connector
should have a plug.
When using an emulator with the EZ-KIT Lite board, follow the
connection instructions provided with the emulator.
ADSP-21364 EZ-KIT Lite Evaluation System Manual
) provides access to all of the DAI signals in the
P3
"Codec Setup Switch (SW7)" on page 2-8
Manufacturer
)
Berg
P3
) allows to configure and program the processor.
P4
Manufacturer
)
Mill-Max
P4
Digi-Key
) is the connecting point for a JTAG in-circuit emu-
P5
EZ-KIT Lite Hardware Reference
Part Number
54102-T08-13
Part Number
897-30-004-90-000
ED90003-ND
for
2-19
Advertisement
Table of Contents
