Installation Summary; Introduction; How To Use The Installation Summary Utility - Nortel Meridian 1 Planning, Installation And Operating Instructions

Page 360 of 536

Installation summary

Introduction

How to use the Installation Summary utility

553-3121-210 Standard 3.0
Chapter 22 — Upgrading software
This section describes how to obtain an installation summary using the
Utilities menu.
Summary of steps
The steps to follow to obtain an installation summary are summarized in the
following list. They consist of:
• Selecting the Utilities function.
• Selecting Current Installation Summary utility.
Using the Installation Summary Utility
The following procedure describes how to use the Current Installation
Summary utility.
Procedure 79
Using Current Installation Summary Utility
1 Invoke the Software Installation Program using Overlay 143.
Login to the system by entering LOGI<cr> then the password in
response to PASS?.
Note: The response to PASS? is unique to each system.
Once logged in, enter:
LD 143<cr>
UPGRADE<cr>
If
SOFTWARE INSTALLATION PROGRAM
message appears go to
If
SOFTWARE INSTALLATION PROGRAM
message does not appear repeat Step 1 (this step) and make sure
correct information is entered
January 1999
Step 2