Activating Default Models - Nortel Meridian 1 Planning, Installation And Operating Instructions

Chapter 17 – Connecting the telephones and attendant console

Activating default models

Telephone with a character display
Procedure 24 describes how to activate a default model on a telephone with a
character display.
Procedure 24
Activating the telephone
1 Plug the telephone set into the jack and wait 20 seconds.
Note: The 20 second time interval is required for the system to
determine whether the set is new or if it is being relocated using the
Modular Telephone Relocation feature.
2 Lift the handset. If dial tone is not present, restore the handset
and wait 10 seconds.
Lift the handset and listen for dial tone. (Repeat this procedure
until dial tone is heard.)
If successful, the character display shows either
"MODEL? X"
(if the telephone relocation feature is not in use) or
"RELOC OR MODEL? X"
(if the telephone relocation feature is in use). "X" represents the default
model for the telephone that you are activating.
Note: If the prompt "MODEL X" is not displayed after lifting the
handset, disconnect the telephone from the wall jack, wait five
seconds, and re-insert the telephone into the jack. The telephone now
shows "MODEL X" when the handset is lifted.
3 Press the pound key (#) to select the default model.
The character display shows
"OK, EXTENSION?
XXXX". "XXXX" represents the default extension number for this
telephone type.
Option 11C Compact Planning, Installation, Fault Clearing and CCBR Guide
Page 173 of 536