Chapter 12 - Adding An Expansion Cabinet; General Information; Cabinet Configurations; Fiber Optic Equipment - Nortel Meridian 1 Planning, Installation And Operating Instructions

Hide thumbs Also See for Meridian 1:

Table of Contents

Chapter 12 – Adding an expansion

Option 11C Compact

Procedure 5 on page 97

cabinets using the 10 m (33 ft) plastic fiber optic cable.

Note: The information contained in this chapter applies to both the

Option 11C Compact and Compact Hospitality unless stated otherwise.

Cabinets are designed to be mounted on a wall. Refer to the

layout plan" on page 38

The following fiber optic equipment is required when adding an expansion

A0632902 Plastic Fiber Optic Cable

This is a 10 m (33 ft) long cable used as a connection between the two

NTDK22 Fiber Expansion daughterboard

Mounts on the NTMW01 SSC card to provide a fiber optic cable

interface connection in the main cabinet.

NTMW10 Fiber Receiver card

Mounts in the expansion cabinet to provide a fiber optic cable interface

connection in the expansion cabinet.

of this chapter describes how to install expansion

for details about equipment layout planning.

Planning, Installation, Fault Clearing and CCBR Guide

Page 95 of 536

Chapters

Table of Contents

Option 11c compact