Nortel Meridian 1 Planning, Installation And Operating Instructions page 257

Page 238 of 536
553-3121-210 Standard 3.0
Chapter 20 — Meridian Mail Compact Option installation and maintenance
Defining voice port hardware locations
To define your voice channels for entries into the Voice Port Hardware
Location table, follow these steps.
Step
1 Select Done on the DSP parameters.
Result The following voice port screen is displayed.
Note: The table below depends on your system configuration as defined by your
keycode and the installed system hardware. Your display may differ.
You have four selections at the "Select operations" prompt which are
revealed each time you press the up or down arrow keys. Select
• "Detailed Display" if you need to see a detailed display of all the
hardware locations on a particular node or range of nodes.
• "Change" if you want to change the port definition on a range of
hardware locations on or across nodes and to modify default
values to the switch agent configuration.
• "Done" if you are satisfied with the default values or your
changes.
• "Reset" if you decide to go back to the default settings after you
have changed them.
2 Press the up or down arrow key until the desired choice is displayed on
the screen, then press <Return>.
Example: Select Change, then press <Return>.
Note: Choices are Voice_Full and Voice_Basic. All entries are changed by
pressing the up or down arrow keys, and then pressing <Return> which moves
you on to the next value.
Note: Meridian Mail Compact Option systems have only 1 node, so enter 1 after
the First and Last Node in the screen in
January 1999
Action
step 3.