Nortel Meridian 1 Planning, Installation And Operating Instructions page 156

Chapter 15 – Installing and connecting SDI and Ethernet ports
Figure 35
J7 Jumper Plug
Procedure 17
Connecting the Ethernet cable
1 Route the Ethernet cable up through the opening at the bottom
rear of the main cabinet.
2 Connect the cable to the 15-pin AUI connector at the bottom of
the main cabinet. See
3 If not previously done, configure the ethernet port in software as
described in the Software Administration Input/Output Guide.
—————————— End of Procedure ——————————
Option 11C Compact
J7 Jumper Plug
Figure 33.
Planning, Installation, Fault Clearing and CCBR Guide
Page 137 of 536