Chapter 1 - Overview Of The Option 11C Compact; Design And Architecture; Easy To Install And Program - Nortel Meridian 1 Planning, Installation And Operating Instructions

Chapter 1 — Overview of the Option 11C
Compact

Design and architecture

Easy to install and program

Option 11C Compact
The Option 11C Compact is a small wall mounted digital PBX system which
can be configured as a one, two or three cabinet system.
Expansion cabinets can be connected up to approximately 33 ft (10 m) from
the main cabinet using an A0632902 10 m (33þft) multi-mode plastic fiber
optic cable.
Note: The A0632902 Plastic Fiber Optic Cable (multi-mode) is the only
fiber optic cable supported by the Option 11C Compact system. The
maximum distance between the cabinets is 33 cable feet (10 cable
meters). Allow approximately 2 ft (0.5 m) of slack at each end of the
cable for routing inside the cabinets.
Call processing, serial ports and network traffic are handled by an MC68040
processor located on the CPU card located in the main cabinet.
The system is shipped with a Software Daughterboard which is
pre-configured with system and a default customer data.
During the first-time installation of the Option 11C Compact system the
Software Installation Program is automatically invoked. This is a menu
driven program which is used to install the software in the system and make
it operational.
Planning, Installation, Fault Clearing and CCBR Guide
Page 1 of 536