*1 Requires a panel with the 3D i-see Sensor (sold separately). An MA remote controller (PAR-40MAA) is required to set the 3D i-see Sensor. Some settings can be made using the
PAR-SL100A-E.
*2 To set the fan speed to Auto using the wireless remote controller, certain controller settings need to be made beforehand. Refer to the installation manual of the wireless remote
controller for details on how to make the settings.
*3 The airfl ow rate mode can be set to either Normal or High. Three fan speeds are available in each mode. Select the mode with the DipSW on the indoor unit. Contact your local
distributor for details.
*4 The available vane angle positions will depend on the remote controller to be used. Refer to the instruction manual of the relevant remote controller for details.
*5 Should be supported by indoor unit and remote controller.