Canon PRISMAsync v3.2 Technical & Service Manual page 98

Preparation of the USB-stick
5. Select Start.
Check that you have the .NET 4.5 framework installed, and press OK if it is installed. Otherwise
Exit the CreateUSB tool and install the .NET 4.5 version. If you don't do this the tool will not work.
NOTE
If the message below appears make sure to download and install the .NET 4.5 framework. The
CreateUSB tool will not work without the .NET 4.5 framework.
4.
Press OK to start the programming process.
Additional illustration needed.
1. After pressing OK the following window will pop-up.
Select "Yes" to store existing jobs and settings, and to restore them automatically after the
installation.
NOTE
The "keep existing jobs and settings after installation" setting is supported in version 3.2 and
higher.
After making the selection, the process will start and the iso-image is programmed to the
stick.
Please wait until the CreateUSB tool indicates that the USB-stick is ejected and the process is
ready
5.
Remove the USB-stick from the PC.
The USB-stick is now ready for use. The name of the stick is OCEINSTALL
After you finish
Reuse a USB-stick after installation on page 99
98 Chapter 9 - System software
PRISMAsync V3.2