Install The Prismasync Supports/Pedestals - Canon PRISMAsync v3.2 Technical & Service Manual

Install the PRISMAsync supports/pedestals

Install the PRISMAsync supports/pedestals
NOTE
To reduce the amount of dust that enters the PRISMAsync controller the supports installed on
the controller have to be replaced with the supplied pedestals.
Replacement of the installed supports
1. Remove the 4 supports installed on the PRISMAsync controller. The removed supports and
screws will not be used.
4x
2. Install the supports delivered with the PRISMAsync controller (4x M3x16 Hex bolt).
4x
18 Chapter 3 - Installation
PRISMAsync V3.2