Canon PRISMAsync v3.2 Technical & Service Manual page 85

step Action
Remove USB key with Printer firmware
12
Check the versions
step Action
1 Print configuration pages:
• PRISMAsync configuration report
• PRISMAsync color configuration re-
port
• Printer: P-Print
Example
Additional information
For additional information see
PRISMAsync V3.2
additional Info
The duration of the printer upgrade procedure
depends on the configuration that is installed.
Example: Main Engine, POD Deck, Finisher
AJ2 and 3 knife trimmer will take approx. 45
minutes.
If a HCS-F1/G1 is connected the additional
time will be approx. 30 minutes.
additional Info
Compare the configuration report and the P-
Print with the version list as stated in the serv-
ice bulletin and release notes.
Firmware upgrade additional information on page 92
Chapter 8 - Firmware upgrades via PRISMAsync
Firmware upgrade of Engine and Accessories
NOTE
Explicitly check the SORTER ver-
sion. If the version does not corre-
spond, make a USB key with the
SORTER package only and do an in-
stallation again. There is no need to
go to Safe Download Mode now.
85