Restart The Copier Only - Canon PRISMAsync v3.2 Technical & Service Manual

Restart the copier only

After the copier is switched off using the power switch an errorcode (11506 Connection lost) will
occur. The PRISMAsync has to be restarted to resolve this error.
To reduce the time necessary to restart the PRISMAsync in such a case, two situations are
described below to restart the copier only.
Restart copier in Service Mode
1. In Service Mode, switch off the copier. The following screen will be displayed:
[12] Error 11506 in Service Screen
In the bar the error code 11506 is shown and the message "Press moonbutton to continue" is
displayed.
2. Press the [Sleep] button.
• After this the error will be reset. If you do not press this button and you will switch to
normal user mode the error screen will be displayed.
3. The Service screen will not function now because the copier is off. You might get the
following screen.
[13] Service Screen when copier is off
4. Switch on the copier. After a few seconds the buttons will turn green again.
Restart copier in Normal Mode
1. In Normal mode switch off the copier with the power switch. The following screen will
appear.
PRISMAsync V3.2
Chapter 5 - Start, shutdown and restart the system
Restart the copier only
53