Canon PRISMAsync v3.2 Technical & Service Manual page 101

5.
Switch on the PRISMAsync
Press the [Sleep] button to switch on the PRISMAsync. In case the "keep existing jobs and
settings after installation" was enabled during creation of the USB-stick an additional reboot after
restoring the jobs and settings will be executed.
NOTE
The "Restore the system settings and licenses" procedure is applicable when:
• The setting "Keep existing jobs and settings after installation" was NOT selected during
creation of the USB stick.
• The HDDs or controller has been replaced
6. Restore the system settings and licenses
To restore the settings and licenses do the following:
1. Insert the USB stick you used to backup the settings, into the left side of the Operator panel.
2. In the System section of the Maintenance tab on the Operator panel, touch [Go to service
mode].
See also Service mode in
3. In the first screen touch the ´Restore' button. The system will detect the USB stick and will ask
to confirm the location and filename. After confirmation, the settings are copied to the
PRISMAsync.
4. When all the settings are copied, the PRISMAsync will automatically reboot. When ready,
please remove the USB-stick. If you were not able to make a backup of the settings before
installation, please use the last backup file you have created.
7. If necessary install patches. (if applicable)
It is possible that there are patches belonging to the new installed system software. Install these
patches now. See next chapter.
8. Make a new backup of settings
NOTE
If you installed the software because the controller was exchanged you have to re-host the
license because the original license that was stored in the back-up is not valid.
PRISMAsync V3.2
Maintenance and Service on page
Re-installation of the system software
31.
Chapter 9 - System software 101