How To Improve Black Density On The Print - Canon PRISMAsync v3.2 Technical & Service Manual

How to improve black density on the print

Description
On some media the density of black is too low.
Solution
There is a setting available to improve the Black density. It can be adjusted in the "Printer
adjustment" section of the specified media.
Procedure
1.
In your browser open the Settings Editor and go to "Media"
2. Select the media and then select "Printer adjustment".
3.
In the "Advanced" section select "Gloss and Fine black adjustment"
4.
Adjust the value to your need. You can change it between -2 and +2. These values are related to
the Gloss-setting. However the Fine-Black setting will also change when you change the Gloss-
Setting. The following relation exists:
Gloss
-2
-1
0
+1
+2
5.
Please take care that this setting can only be used for Plain paper. (So not for coated, vellum etc.)
PRISMAsync V3.2
How to improve black density on the print
Fine Black
2
1
0
0
0
Chapter 11 - Appendix 135