Canon PRISMAsync v3.2 Technical & Service Manual page 24

Finish the installation
Step Action
11 Set the billing counters that have to be displayed on the Operator Panel.
a. Go to Service Mode
b. Select COPIER>OPTION>USER 11.
c. Make the following settings:
- CNT_SW 0
- Counter1 112 Total (Black/Large)
- Counter2 113 Total (Black/Small)
- Counter3 122 Total (Full Color + Single Color/Large)
- Counter4 123 Total (Full Color + Single Color/Small)
- Counter5 102 Total 2
- Counter6 0
- Counter7 0
- Counter8 0
12 Assist the customer with the installation of the printer-driver on 1 workstation.
The printer driver can be found by using the Settings Editor.
• On your PC open an Internet browser (e.g. Microsoft Explorer)
• In the Address bar enter http://<hostname> or IP-address
• A window with the Settings Editor will open. Go to the [Support] tab
• Touch [Software]. At the bottom of the page you will find the drivers which can be
• Install the driver needed (Windows, Mac OS)
• Make some test prints with the driver.
13 Ask the customer to make sure that all media (CDs and/or USB sticks) shipped with
the PRISMAsync are stored in a safe location.
CAUTION
Do not store any media or paper (USB keys or reports) inside the PRISMAsync be‐
cause of fire-hazard.
24 Chapter 3 - Installation
NOTE
Additional toner bottle counters can be displayed . Ask the customer for
preferences
• Selection of counters via Engine Service mode
• Counters can be retrieved via eRDS/UGW
• Not supported by SNMP
downloaded to your computer
PRISMAsync V3.2