Restart Copier After Error In Copier - Canon PRISMAsync v3.2 Technical & Service Manual

Restart copier after error in copier

It is possible to restart the copier without restarting the PRISMAsync. This is useful if an error
occurred in the copier resulting in an E-code.
The customer has to follow the steps indicated at the left side of the screen.
Procedure
1.
Switch all finishers and paper modules off.
2. Check if power cords are plugged in.
3.
Wait at least 3 seconds
4. Switch all finishers and paper modules on
5.
Press the [Sleep] button to restart the printer.
NOTE
The copier will restart without restarting the PRISMAsync.
NOTE
In some cases the system needs to reboot the engine (max. 2x) to reach the correct start-up
situation.
PRISMAsync V3.2
Restart copier after error in copier
Chapter 5 - Start, shutdown and restart the system 55