Canon PRISMAsync v3.2 Technical & Service Manual page 37

lifetime. Doing so is the easiest way for the Field Service Technician to get an overview of the
status of all parts. For a more detailed description see the appendix
6. External Finishers
If there are External finishers connected to the copier then you have to set parameters to
make the connection work properly.
For a description of these parameters see the Service Manual of the copier.
7. Backup
Make a backup of the PRISMAsync settings. Insert a USB-stick into the USB-port on the
operator panel. The system will point to this stick. After accepting the pathname the settings
are written to this USB stick. The filename will contain the time of the backup. Always
perform the backup, before servicing the PRISMAsync.
8. Restore
Restore the settings that were written on the USB-stick during a backup procedure. Insert the
USB-stick into the USB-port on the operator panel. The system will ask for a filename.
After selecting the correct file, the settings are restored to the PRISMAsync. When restoring is
ready the PRISMAsync will reboot automatically.
9. Customer Specific Solutions
For some customers it is possible that specific solutions for their system are made.
In this screen you can disable or enable these solutions.
10. POC Configuration
In the POC configuration screen you can determine which Key Operator (Printer Operator
Care) actions the customer is allowed to do with respect to the High Capacity Stacker F1.
If it is enabled then a wizard will show up guiding the customer through the actions.
11. Error Analysis
An overview of the most recent errors is presented on the screen.
12. POC history
The most recent Key Operator Maintenance actions are presented on the screen
13. Modifications
An overview of the modifications on the system is presented on the screen. You can view/
register modifications for the copier, the scanner and the PRISMAsync controller.
PRISMAsync V3.2
System service mode (PRISMAsync service mode)
Chapter 4 - Using the PRISMAsync 37