Replace The Base Controller - Canon PRISMAsync v3.2 Technical & Service Manual

Replace the Base controller

Replace the Base controller
If it is clear that an error can only be solved by replacing the motherboard a new base controller
can be ordered as a service part. This controller has all the hardware in it without the extra
boards that are added to make it a PRISMAsync controller (DDI board, AUX Control Board,
Ethernet Board, 22W1 Harness).
NOTE
When servicing components of the PRISMAsync always wear a grounded strap around your
wrist, to avoid electrostatic discharge that will harm your equipment.
Perform the following actions to exchange the controller:
Step Action
1 Remove side cover and middle bracket.
• Follow the instructions as described in
2 Remove extra boards
• Remove the following boards:
3 Remove harness 22W01
Remove the connections at the backside of the PRISMAsync
4
5 Unpack the base controller
6 Remove side cover and middle bracket.
• Follow the instructions as described in
7 Insert previously removed boards
• Insert the following boards:
8 Connect Harness 22W01
• See
9 Re-install middle bracket and side cover.
• Take care that the fixing on the middle bracket is in position. It should fit exactly on
76 Chapter 7 - Service procedures
Replace the DDI board on page 70
• DDI board (See:
• AUX Control board (See:
Check if you need a newer version of the AUX control board. (See conditions
above) If so, you do not have to remove the board.
• Additional Ethernet board (IPDS) (See:
page 75)
• (Optional) HDDs. (See:
If HDDs are still working you can exchange the hard disks. In this case all set-
tings and jobs will be saved and no new system software installation is nee-
ded.
Replace the DDI board on page 70
• DDI board (See:
• AUX Control board (See:
Re-use the old board if possible, otherwise insert the new board. Be aware
that you have to connect the 22W01 harness too.
• Additional Ethernet board (IPDS) (See:
page 75 )
• (Optional) HDDs.
Replace the Hard Disk Drives on page 74
(See:
possible to re-use the HDDs.
Connect Harness 22W01 on page 78
the boards.
Access internal components on page
Replace the AUX control board on page 71
Install/Replace the Ethernet board on
Replace the Hard Disk Drives on page 74
Access internal components on page 67
Replace the AUX control board on page 71
Install/Replace the Ethernet board on
)
)
)
)
)
) See conditions above if it is
PRISMAsync V3.2
67.
.
4