Byte, Word, And Long-Word Read Cycle Flowchart - Motorola M68060 User Manual

• Accesses that do not allocate in the data cache on a read miss (exception vector fetch-
es, and exception stack deallocation for an RTE instruction)
• The first transfer of a line read is terminated with transfer burst inhibit (TBI), forcing com-
pletion of the line access using three additional long-word read transfers
Figure 7-12 is a flowchart for byte, word, and long-word read transfers. Bus operations are
similar for each case and vary only with the size indicated and the portion of the data bus
used for the transfer. Figure 7-13 is a functional timing diagram for byte, word, and long-
word read transfers.
1) SET R/W TO READ
2) DRIVE ADDRESS ON A31–A0
3) DRIVE UPA1–UPA0, TM2–TM0, CIOUT,
TLN1–TLN0, LOCK, LOCKE, BS3–BS0
4) DRIVE SIZ1–SIZ0 TO BYTE, WORD, OR LONG
5) ASSERT TS FOR ONE BCLK
6) ASSERT TIP
7) ASSERT SAS IMMEDIATELY IF
ACKNOWLEDGE TERMINATION IGNORE
STATE CAPABILITY DISABLED. ELSE,
ASSERT SAS AFTER READ PRIMARY
IGNORE STATE COUNTER HAS EXPIRED
1) REGISTER DATA
2) NEGATE LOCK, LOCKE IF NECESSARY
1) NEGATE TIP OR START NEXT CYCLE
Figure 7-12. Byte, Word, and Long-Word Read Cycle Flowchart
Clock 1 (C1)
The read cycle starts in C1. During C1, the processor places valid values on the address
bus and transfer attributes. For user and supervisor mode accesses, which the corre-
sponding memory unit translates, the user-programmable attribute signals (UPAx) are
driven with the values from the matching user bits (U1 and U0). The transfer type (TTx)
and transfer modifier (TMx) signals identify the specific access type. The read/write (R/W)
signal is driven high for a read cycle. Cache inhibit out (CIOUT) is asserted since the ac-
cess is identified as noncachable. Refer to Section 4 Memory Management Unit for in-
formation on the MC68060 and MC68LC060 memory units and Appendix B MC68EC060
for information on the MC68EC060 memory unit.
MOTOROLA
PROCESSOR
M68060 USER'S MANUAL
SYSTEM
1) DECODE ADDRESS
2) PLACE DATA ON APPROPRIATE BYTE
LANES BASED ON SIZ1–SIZ0, A1–A0, OR
BS3–BS0
3) ASSERT TA AROUND RISING EDGE OF
BCLK.
1) THREE-STATE D31–D0
Bus Operation
7-13