ProMinent Splash Control Pro 2 Assembly And Operating Instructions Manual page 68

Communication programming instructions
68
MODEM
ETHERNET
TCP/IP settings
DHCP enabled:
IP Address
Mask
Gate
Fig. 64: Ethernet modem configuration [6731]
DHCP enabled
Selection of the DHCP configuration of your network.
n
Press the key to ENABLE/DISABLE DNS.
n
IP Address
If you disable DHCP, you need to enter the fixed IP address of
n
your device. Press the key to open the numeric keyboard and
enter the required value.
Mask
If you disable DHCP, you need to enter the subnet mask of
n
your network. Press the mask to open the numeric keyboard
and enter the required value.
Gate
If you disable DHCP, you need to enter the gateway of your
n
network. Press Gate to open the numeric keyboard and enter
the required value.
Automatic DNS
Selection of the DNS configuration. Press the Automatic DNS
n
key to ENABLE/DISABLE DNS.
Preferred DNS 8.8.8.8.8
If DNS management is not automatic, you need to enter the IP
n
address of the primary DNS.
Press Preferred DNS to open the numeric keyboard and enter
n
the required value.
Secondary DNS 8.8.4.4
If DNS management is not automatic, you need to enter the IP
n
address of the secondary DNS.
Press Secondary DNS to open the numeric keyboard and enter
n
the required value.
Saving
When a change has been made, the "Save" button (disk
n
symbol) appears, which you need to press to save your config‐
uration.
Automatic DNS
8.8.8.8.8.8
Preferred DNS
8.8.4.4
Auxiliary DNS
A3060