Table 20. Riser configuration (include slots 1, 2, and 3) (continued)
Card type
KIT,CRD,CTL,HBA,12GBPS-
SAS,Dell,HBA: External Adapter
LOM riser ( 2x1 G)/(2x10 G)/(2x25 G)
Removing the expansion card risers
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the air
shroud.
4. Disconnect any cables connected to the expansion card.
Steps
Hold the touch points, and lift the expansion card riser from the riser connector on the system board.
Figure 54. Removing the low profile left riser
NOTE:
For low profile riser right, first loosen the captive screw and then holding the touch points lift the riser away from
the system.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
64
Installing and removing system components
Slot priority
3,2
1
Safety
instructions.
Before working inside your
Maximum number of cards
2
1
system.