Table of Contents
Advertisement
Figure 92. Removing the VGA module
Next steps
Replace the VGA
module.
Installing the VGA module
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3.
Remove the front
bezel.
4.
Remove the backplane
5.
Remove the air
shroud.
NOTE:
Ensure that you note the routing of the cables as you remove them from the system board. Route the cable
properly when you replace it to prevent the cable from being pinched or crimped
Steps
1. Route the VGA cable through the VGA module slot on the front of the system and slide the VGA module into the slot.
2. Align the hole on the module with the screw hole on the system.
3. Using the Phillips #1 screwdriver, secure the VGA module to the system with the screw.
Safety
instructions.
Before working inside your
cover.
system.
Installing and removing system components
89
Advertisement
Table of Contents
