Installing The Vga Module - Dell PowerEdge HS5610 Installation And Service Manual

NOTE: Ensure that you note the routing of the cables as you remove them from the system board. Route the cable
properly when you replace it to prevent the cable from being pinched or crimped
Steps
1. Using Phillips 1 screwdriver, remove the screw on the VGA module.
2. Slide the module out of the system.
Figure 153. Removing the VGA module
Next steps
Replace the VGA module.

Installing the VGA module

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. Remove the front bezel.
4. Remove the backplane
5. Remove the air shroud.
NOTE: Ensure that you note the routing of the cables as you remove them from the system board. Route the cable
properly when you replace it to prevent the cable from being pinched or crimped
Steps
1. Route the VGA cable through the VGA module slot on the front of the system and slide the VGA module into the slot.
Safety instructions.
Before working inside your system
cover.
.
Installing and removing system components 181