Table of Contents
Advertisement
3.
Remove the expansion card
NOTE:
Ensure that you note the routing of the cable as you remove it from the system board. Route the cable properly
when you replace it to prevent the cable from being pinched or crimped.
Steps
1. Align the intrusion switch module into the slot in the system until firmly seated.
2. Using a Phillips #1 screwdriver, tighten the screws on the intrusion switch module.
3. Connect the intrusion switch cable to the connector on the rear I/O board.
Figure 148. Installing the intrusion switch module
Next steps
1.
Install the expansion card
2. Follow the procedure listed in
Optional OCP card
Removing the OCP card
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the expansion card
Steps
1. Open the blue latch to disengage the OCP card.
2. Push the OCP card towards the rear end of the system to disconnect from the connector on the system board.
3. Slide the OCP card out of the slot on the system.
riser.
riser.
After working inside your
Safety
instructions.
Before working inside your
riser.
system.
system.
Installing and removing system components
177
Advertisement
Table of Contents
