Kodak X-Omat 460 RA Processor Installation Instructions Manual page 9

[2] Remove the FEED-END, LOWER ACCESS PANEL and the 2 SIDE PANELS from the processor for
easier access.
[3] Move the processor so that one corner is off the SHIPPING SKID.
To prevent damaging the LEVELING SCREWS and the processor, do not allow more than a
25 mm (1 in.) clearance between the bottom of the processor and the HEAD of the LEVELING
SCREW.
[4] Insert a LEVELING SCREW into the corner of the processor that is off the SKID.
[5] Move another corner of the processor from the SKID.
[6] Insert a LEVELING SCREW into that corner of the processor.
[7] Do Steps ?? and ?? for the remaining 2 corners of the processor.
636738
LEVELING
SCREW
HEAD
Figure 8 Leveling Screw
H108_0036ACA
H108_0036AA
9