Kodak X-Omat 460 RA Processor Installation Instructions Manual page 39

Connecting the Replenishment Tanks
[1] Install one end of the STRAINER onto the TUBING leading from the REPLENISHMENT TANK.
[2] Install the other end of the STRAINER to the TUBING leading into the processor.
[3] Connect the TUBING from the INLET on the REPLENISHER PUMP ASSEMBLY to the
REPLENISHMENT TANK.
Since this processor has very high pumping rates, make sure the tubing is straight and not kinked.
REPLENISHMENT
PUMP ASSEMBLIES
After following the above procedures for the installation of the DEVELOPER REPLENISHMENT TUBE, repeat
the above procedures for the installation of the FIXER REPLENISHMENT TUBE.
636738
IMPORTANT
STRAINERS
Figure 44 Installing the Replenishment Tubing
REPLENISHMENT
TANKS
H108_0014BCA
H108_0014BA
39