Kodak X-Omat 460 RA Processor Installation Instructions Manual page 28

[11] Check the alignment of the DRIVE BELT. Adjust the PULLEY as necessary. When the processor is
operating, check that this alignment is correct. See Figure ?? on page ??.
[12] Deenergize the processor by moving the MAIN CIRCUIT BREAKER, CB1, to the ''O'' position.
[13] Install the BLOWER MOTOR COVER.
[14] Install the FEED-END, MIDDLE ACCESS PANEL onto the processor.
28
Do not place hands or fingers near the moving parts.
SMALL
DIAMETER
Figure 33 Positioning the Blower Motor and Drive Belt
LARGE
DIAMETER
DRIVE
BELT
BLOWER
MOTOR
H108_0015BCA
H108_0015BA
636738