Kodak X-Omat 460 RA Processor Installation Instructions Manual page 35

[4] Connect the DUCT to the processor.
DUCT from
PROCESSOR
Figure 40 Connecting the Processor Exhaust to the Building Exhaust
Connecting the Exhaust Fan for Intermittent Operation
The processor is shipped with the exhaust fan wired for continuous operation while the processor
is energized. For the exhaust fan to operate intermittently, do the following:
[1] Remove the RECEIVING-END ACCESS
PANEL.
[2] Open the ELECTRICAL BOX COVER.
[3] Disconnect wire 20-25 from TB4-3 and
connect it to TB4-4.
[4] Close the ELECTRICAL BOX COVER.
[5] Install the RECEIVING-END ACCESS PANEL.
636738
Adjust clearance to obtain
required static pressure in duct.
Do not make solid connection.
5.1 cm (2.0 in.)
maximum
NOTE
Figure 41 Wiring for Intermittent Operation
of the Exhaust Fan
H108_0008BCB
H108_0008BA
H108_0087AA
35