Kodak X-Omat 460 RA Processor Installation Instructions Manual page 7

[15] From the NON-DRIVE SIDE of the processor, remove the CARDBOARD securing the ends of the
DRYER AIR TUBES in place.
[16] Remove the 10 OUTER DRYER AIR TUBES to access the PACKING MATERIAL around the SHAFTS of
the AIR TUBES and ROLLERS.
[17] Remove the PACKING MATERIAL.
[18] Insert the 10 OUTER DRYER AIR TUBES back into the side frame of the dryer placing the flat side of
the AIR TUBE up.
If you are unpacking the processor anywhere other than in its final destination, make sure to
either install all removed parts or pack them carefully with the processor for transport.
636738
CARDBOARD
Figure 6 Removing Cardboard from around Dryer Air Tubes
PACKING
MATERIAL
DRYER
AIR
TUBES
NOTE
H108_0062BCA
H108_0062BA
7