Kodak X-Omat 460 RA Processor Installation Instructions Manual page 36

Installing the Grommets and Replenishment Tubes
To prevent contaminating the processor solutions, follow the instructions below to install the
DEVELOPER REPLENISHMENT TUBE. After the DEVELOPER REPLENISHMENT TUBE is
connected to the DEVELOPER REPLENISHMENT TANK, then, repeat the following procedure to
install the FIXER REPLENISHMENT TUBE.
[1] Insert the REPLENISHMENT TUBE through one of the SLOTS in the FEED END of the processor. See
Figure ??. (The tubing is not supplied.)
Only thick walled TUBING will withstand the high suction of the REPLENISHER PUMPS.
REPLENISHMENT TUBES may instead be inserted into the holes in the bottom of the processor.
For further details, see the procedure on page ??.
36
NOTE
NOTE
636738