Kodak X-Omat 460 RA Processor Installation Instructions Manual page 12

Aligning the Film Guide
[1] Insert a 35 x 43 cm (14 x 17 in.) film into the FILM GUIDE.
[2] Use the edges of the film to align the FILM GUIDE with the DETECTOR CROSSOVER ASSEMBLY.
[3] Tighten the 3 WING NUTS.
Installing the Light Hood
[1] Remove the outer 2 SCREWS above the FEED TRAY. See the figure.
[2] Align the holes in the LIGHT SHIELD with the 2 SCREW HOLES.
[3] Install the 2 SCREWS removed in Step 1 through the LIGHT SHIELD and into the processor.
[4] Remove the RECEIVING-END ACCESS PANEL from the processor.
[5] Circle number 5 on the MODIFICATION LABEL.
[6] Install the RECEIVING-END ACCESS PANEL onto the processor.
SCREW
12
FEED SHELF
WING NUT (3)
SCREW (5)
Figure 12 Aligning the Film Guide
Figure 13 Installing the Light Shield
FILM
GUIDE
DETECTOR
CROSSOVER
ASSEMBLY
H108_0034BCA
H108_0034BA
SCREW
H108_0170BCA
H108_0170BA
636738