Kodak X-Omat 460 RA Processor Installation Instructions Manual page 11

[2] Install the FILM GUIDE onto the FEED SHELF using:
• 3 WING NUTS
• 3 WASHERS.
WING NUT (3)
SCREW (5)
Adjusting the Height of the Feed Shelf
[1] Adjust the position of the FEED SHELF so
that it is approximately 1 mm (1/16 in.) lower
than the NIP of the DETECTOR
CROSSOVER ROLLERS.
[2] When the height is adjusted correctly, tighten
the 5 SCREWS as shown.
Do not tighten the WING NUTS.
636738
Do not tighten the WING NUTS.
FEED SHELF
Figure 10 Installing the Feed Shelf
NOTE
NOTE
FILM
GUIDE
1mm (1/16 in.)
Figure 11 Adjusting Feed Shelf Height
WASHER (5)
LOCKWASHER (5)
H108_0033BCA
SCREW (5)
DETECTOR
CROSSOVER
ENTRANCE
ROLLERS
SCREW (4)
H108_0038ACA
H108_0033BA
NIP
H108_0038AA
11