Kodak X-Omat 460 RA Processor Installation Instructions Manual page 21

Connecting the Jumpers at
Terminal Strip TB2
[1] Remove the FEED-END, LOWER ACCESS
PANEL from the processor.
[2] Open the TRANSFORMER BOX COVER.
[3] Determine the SUPPLY VOLTAGE being
applied to the processor.
[4] Remove the JUMPERS from the PRE-PACK
CARTON which came packed with the
processor in the SHIPPING CARTON. See
Figures ?? through ?? on pages ?? through
??, and connect the JUMPERS to TERMINAL
STRIP TB2.
[5] Route the JUMPER WIRES neatly so that the
wires do not become pinched or scraped
when you close the TRANSFORMER BOX
COVER.
FEED-END
LOWER ACCESS PANEL
Figure 25 Feed-End Access Panels
Connecting the Wiring to the Terminal Strip
[1] Connect the MAIN INPUT POWER WIRES to
TERMINAL STRIP TB1 and to the
GROUNDING LUG.
Wiring must meet all local codes.
636738
Connecting the Processor
H108_0137ACA
H108_0137AA
NOTE
[2] Close the TRANSFORMER BOX COVER.
[3] Install the FEED-END, LOWER ACCESS
PANEL onto the processor.
CONDUIT
GROUNDING
LUG
TB2
TRANSFORMER
BOX COVER
Figure 26 Transformer Box Interior
TBI
H108_0056CCA
H108_0056CA
21