Kodak X-Omat 460 RA Processor Installation Instructions Manual page 38

Installing the Replenishment Tubes Through Alternate Inlets
To prevent contaminating the processor solutions, follow the instructions below to install the
DEVELOPER REPLENISHMENT TUBE. After the DEVELOPER REPLENISHMENT TUBE is
connected to the DEVELOPER REPLENISHMENT TANK, then, repeat the following procedure to
install the FIXER REPLENISHMENT TUBE.
[1] Insert the REPLENISHMENT TUBE through one of the HOLES in the BOTTOM of the processor. (The
tubing is not supplied.)
Only thick walled TUBING will withstand the high suction of the REPLENISHER PUMPS.
[2] Install a GROMMET onto the REPLENISHMENT TUBE. If necessary, remove a section of the
GROMMET.
[3] Compress the GROMMET and fit it into the HOLE in the BOTTOM of the processor.
Figure 43 Using the Alternate Inlets for the Replenishment Tubes
38
NOTE
ALTERNATE
INLETS
H108_0140ACA
H108_0140AA
636738