Kodak X-Omat 460 RA Processor Installation Instructions Manual page 30

Hide thumbs Also See for X-Omat 460 RA Processor:

Installing Language Chips

To change either to or from a Japanese display—

[1]

Make sure that the processor is deenergized. Move the MAIN CIRCUIT BREAKER, CB1, and

AUXILIARY CIRCUIT BREAKERS CB2, CB3, and CB4 to the ''O'' position.

[2]

Remove the RECEIVING-END ACCESS PANEL

Before removing any CHIP from the 500 CIRCUIT BOARD, make sure you are wearing a

wrist grounding strap to prevent damage from electrostatic discharge.

[3]

Loosen the SCREW on the ELECTRICAL BOX to access the 500 CIRCUIT BOARD.

[4]

Using the special tool, TL-4398, grip LANGUAGE CHIP U17 and pull it up and out of the SOCKET on

the 500 CIRCUIT BOARD.

[5]

Place the new LANGUAGE CHIP U17 into the empty SOCKET on the 500 CIRCUIT BOARD in the

position where the old LANGUAGE CHIP U17 was.

CHIPS U17, U18, U19, and U20 are keyed. These CHIPS must be positioned in their SOCKET

correctly, otherwise they will not function. See the figure for the correct orientation of these

CHIPS.

Keyed corner

of CHIP

Keyed corner

of SOCKET

Figure 35 Orienting Chips into their Sockets

IMPORTANT

H108_0177BCA

H108_0177BC

636738