Electrical Safety - GLP impression X5 Quick Start And Safety Manual

German Light Products
● Respect all warnings and directions given in the fixture's user documentation and
on the fixture. Read the user documentation and familiarize yourself with the
safety precautions it contains before installing or using the fixture. GLP and
affiliated companies will take no responsibility for damage or injury resulting from
disregard for the information in the fixture's user documentation.
● Check the GLP website at www.glp.de and make sure that you have the latest
version of this manual. Check the fixture software version indicated on page 2 of
this manual and then use the fixture's control panel to check the version installed
in the fixture. If the versions are not the same, this manual may still cover the
fixture, because software updates do not always affect the use of the fixture.
However, it is possible that this manual does not match the fixture perfectly.
Software release notes can help clarify this question. You can consult software
release notes and download the correct version of this manual on the GLP
website if necessary.
● Make all user documentation available to all installers and operators. Save user
documentation for future reference.
● If you have any questions about the safe operation of the fixture, please contact
an authorized GLP distributor (see list of distributors at www.glp.de).
● Use the fixture only as directed in this manual. Observe all markings in this
manual and on the fixture.
● Refer all repairs and any service operation not described in this manual to a
technician authorized by GLP.
● The LED light source in the impression X5 is not user-replaceable.
● Read and follow the user documentation for all additional equipment.

Electrical safety

● Do not allow the fixture to come into contact with water or moisture.
● Use only a source of AC mains power that complies with local building and
electrical codes and has both overload and ground-fault (earth-fault) protection.
● Ensure that the fixture is electrically connected to ground (earth).
● Disconnect the fixture from AC mains power before carrying out any installation
or maintenance work and when the fixture is not in use.
● Disconnect the fixture from power immediately if any seal, cover, cable, connector
or other component is damaged, defective, deformed or showing signs of
overheating. Do not reapply power until the fixture has been repaired and made
safe by a technician authorized by GLP.
● Check that all power distribution equipment, cables and connectors are in perfect
condition, rated for the electrical requirements of all connected devices, suitable
for their application and suitable for the installation environment.
impression X5 Quick Start and Safety Manual Rev. 20220505-01
®
impression X5
5