Valve Spring Installation - Linhai M565Li T3 EFI Service Manual

NOTE: Ensure to turn reamer in the right
CHAPTER 3 ENGINE
direction. Use cutting oil and make
brakes to clean reamer/valve guide from
Valve Guide
1.
metal shavings.
Valve Guide Diameter
A.
CAUTION: Be careful when valve stem
is passed through sealing lips of valve
stem seal.

Valve Spring Installation

For installation, reverse the removal
CAUTION: An improper locked valve
procedure (Check 5-45). Pay attention to
spring will cause engine damage.
the following details.
Rocker Arm Installation
●
Colored area of the valve spring must be
NOTE: Use the same procedure for
placed on top.
●
To ease installation of cotters, apply oil
or grease on them so that they remain in
M565Li T3 EFI SERVICE MANUAL 20.0
Valve Seat
1.
Valve Face(contact surface to valve
2.
seat)
Turn valve while pushing against
3.
cylinder head
Valve Seat Angle 45
A.
Valve Spring Lower Seat
1.
2.Sealing Lips of Valve Stem Seal
place while releasing the spring.
NOTE: Valve cotter must be properly
engaged in valve stem grooves.
●
After spring is installed, ensure it is
properly locked by tapping on valve stem
end with a soft hammer so that valve opens
and closes a few times.
CHAPTER 3 ENGINE PAGE. 3-
51