Linhai M565Li T3 EFI Service Manual page 266

CHAPTER 5 FINAL DRIVE
tabs facing toward the rear of the
vehicle .
15. Move the small boot band onto the boot.
Bend down the tab on the boot band and
secure the tab with the locking clips and
tap them with a plastic hammer. Make
sure they are locked in place.
16. Install the large boot bands onto each
boot.
CAUTION
It is critical to avoid undue stress on the
rubber boots after the drive axle is
installed and the vehicle is run. Don't
twist the boot, and always set the both
ends in designed position.
17. Secure all large boot bands. Bend down
the tab on the boot band and secure the
tab with the locking clip and tap them with
a plastic hammer. Make sure they are
locked in place.
18. If removed, install the stopper ring and
make sure it is seated correctly in the
drive axle groove.
19. Apply molybdenum disulfide grease to the
end splines.
M565Li SERVICE MANUAL 2019.0
CHAPTER 5 FINAL DRIVE. 5- 12