Linhai M565Li T3 EFI Service Manual page 152

CHAPTER 3 ENGINE
Drive Bevel Gear
● To protect the drive bevel gear shaft by
one clean duster cloth and clamp by vise
● Loosen the Drive Bevel Gear Nut (3),re-
move Drive Bevel Gear(4) and Adjusting
spacer(5).
● To inspect Drive Bevel Gear (4) and
Out- put Driven Gear (2) for rust, cracks,
wear. Replace it if necessary.
● To inspect Bearing (8) for turning.
Replace it if abnormal.
● To adjust Adjusting Spacer (5) if replace
any one of Crankcase (Right), Drive
Bevel Gear (4), Drive Bevel Gear cover
(1). Detail to check Bevel Gear adjusting
method
●To tighten tight Nut (3) by standard
torque and with lubricating oil on bearing
(8) before install.
Service Limit (Drive Bevel Gear Tight
Nut): 140~150N.m
M565Li T3 EFI SERVICE MANUAL 20.0
1- Drive Bevel Gear Cover
2- Output Driven Gear Bear
3- Drive Bevel Gear Nut
4- Drive Bevel Gear
5- Adjusting spacer
6- Drive Bevel Gear Shaft
7- Bearing Plate
CHAPTER 3 ENGINE PAGE. 3-
81