Procedure Of Maintenance & Adjustment; Valve Clearance - Linhai M565Li T3 EFI Service Manual

CHAPTER 3 ENGINE
3.2.2 Procedure of Maintenance &
Adjustment
This section describes the maintenance
procedures for each item mentioned in the
periodic maintenance chart.
Inspect initially at 20-hour break-in and
every 40 hours or every 1000km thereafter.
Inspect the clearance after removing
cylinder head

3.2.3 Valve clearance

Excessive valve clearance results in valve
noise and insufficient valve clearance
results in valve damage and reduced
power.
Check the valve clearance at the period
indicated above and adjust the valve
clearance to specification, if necessary.
● Remove CVT case cover (1)；
●
Remove RPM sensor(2) of left
crankcase cover
● Remove cylinder head cover (3)；
● Turn the crankshaft until the line( 4) of T.
D.C. on rotor is aligned with mark (5) of
inspection hole on left crankcase..
● Insert feeler gauge to check the
clearance between the valve stem end
and the adjust bolt on the rocker arm.
Valve clearance Intake valve
0.06mm～0.08mm
（When cold)
；
Exhaust valve
M565Li T3 EFI SERVICE MANUAL 20.0
3
CHAPTER 3 ENGINE
1
2
5
4
PAGE. 3- 20