Wheel Installation - Linhai LH500ATV-D Owner's/Operator's Manual

16. MAINTENANCE
WARNING
Operating your ATV with worn tires, improperly inflated tires, non-standard
tires or improperly installed tire will affect vehicle handling which could cause
an accident resulting in serious injury or death.
Follow the safeguards listed below to prevent this type of situation.
Important Safeguards
Maintain proper tire pressure according to charts below. Improper tire inflation
may affect ATV maneuverability.
Do not use improper tires. The use of non-standard size or type tires may
affect ATV handling.
Make certain the wheels are installed properly. If wheels are improperly
installed it could affect vehicle handling and tire wear.
Wheel Removal Procedure
1. Stop the engine, place the transmission in gear and lock the parking brake.
2. Loosen the wheel nuts slightly.
3. Elevate the side of the vehicle by placing a suitable stand under the footrest
frame.
4. Remove the wheel nuts and remove the wheel.
Tire Pressure
front
96kPa/14PSI

Wheel Installation

1. With the transmission in gear and the parking brake locked, place th wheel
in the correct position on the wheel hub. Be sure the valve stem is toward the
outside and totation arrows on the tire point toward forward rotation.
2. Attach the wheel nuts and finger
tighten them.
3. Lower the vehicle to the ground.
4. Securely tighten the wheel nuts
according to the chart found in
OWNER'S/OPERATOR'S MANUAL
LH500ATV-D
rear
96kPa/14PSI
14.0
16-21