Linhai M565Li T3 EFI Service Manual page 311

CHAPTER 7 ELECTRICAL
4.lgnition spark gap
 Disconnect the spark plug cap from the
spark plug
Connect the ignition tester 1 as shown.
2 Spark plug
Turn the main switch to "ON".
Check the ignition spark gap .
Check the spark by pushing the
starter switch, and increase the spark
gap until a misfire occurs.
Minimum spark gap:
6mm (0.24 in)
OUT OF
SPECIFICATION
OR
NO SPARK
5.Spark plug cap resistance
Remover the spark plug cap.
Connect the pocket tester (ΩX1 k) to
the spark plug cap.
NOTE:
 When removing the spark plug cap.
do not pull the spark plug cap from
high tension cord.
Remove→Turning
counterclockwise
Connect→Turning clockwise.
Check the high tension cord
when connecting the spark
plug cap.
 When connecting the spark plug cap,
cut the high tension cord about 5mm.
Spark plug cap
resistance:
10KΩ(20 ℃)
*
CORRECT
M565Li T3 EFI SERVICE MANUAL 20.0
MEETS SPECIFICATION
The ignition system is not faulty.
Tester (+) lead →
Spark plug side
Tester (—) lead→
High tension cord side 
OUT OF SPECIFICATION
Replace the spark plug cap
CHAPTER 7 ELECTRICAL PAGE.7- 7