Throttle Body Removal; Throttle Body Installation - Linhai M565Li T3 EFI Service Manual

CHAPTER 3 ENGINE
Throttle Position Sensor:
Reference voltage: 5±0.1VDC
Resistance between T1 and T2: 3k~12kΩ
Idle Air Control Valve:
Operating voltage: 7.5~14.2 VDC
Solenoid resistance: 53Ω±10%
Solenoid inductance: 33mH±20%
3.5.3.4 Operating Conditions
Normal Operating Temperature: -30~120°C

3.5.3.5 Throttle Body Removal

Disconnect negative terminal of the battery
Disconnect electric lead wire of throttle position sensor coupler, stepper motor coupler
and MAP/MAT sensor coupler ( if this sensor is mounted on the throttle body)
Disconnect accelerator cable from throttle body
Remove air cleaner outlet hose and throttle body outlet hose
3.5.3.6 Cleaning Procedure
If there is cover on the bottom, it may be removed and cleaned using carburetor cleaner
(3M make recommended). Once the throttle body cover is removed, spray the throttle-
body cleaner inside the shipping air passage, and use the brushes to gently dislodge the
dirt, gum and varnish that are present. Do not let the bye pass holes be blocked by dirt or
foreign particles.

3.5.3.7 Throttle Body Installation

M565Li T3 EFI SERVICE MANUAL 20.0
CHAPTER 3 ENGINE PAGE. 3- 112