Linhai M565Li T3 EFI Service Manual page 276

CHAPTER 5 FINAL DRIVE
13. Mount the coupler of the rear axle f with
the bevel gear-driving V.
Mount the washer 12.5×30×4 g.
Apply some Loctite 242 threadlocker on
screw thread.
Tighten the nut M12×1.25 h to a torque of
50~60N.m.
→Fig 13
14. Mount the oil seal 65×90×9 j in the ring
gear bearing housing C on the right.
→Fig 14
Fig 14
15. Mount the oil seal k in the ring gear bearing
housing G on the left.
Make the O-ring m on the fill plug n .
Tighten the fill plug n to a torque of
35~40N.m.
→Fig 15
CHAPTER 5
M565Li SERVICE MANUAL 2019.0
Fig 13
Fig 15
FINAL DRIVE. 5- 22