CHAPTER 4 CHASSIS
4.3 REAR STABILIZER BAR REMOVAL/INSTALLATION
1. Elevate and safely support vehicle with weight
removed from the rear wheel(s).
2. Remove the rear wheel to gain access to the
stabilizer bar, each side.
3. Remove the stabilizer bar nut from the lower
A-arm, each side.
4. Remove the two bolts that secure the stabilizer
bar to the main frame, each side.
5. Remove the stabilizer from the frame.
6. Inspect the stabilizer bar. Inspect the bushings
and replace if needed.
7. Inspect the stabilizer joint and replace if needed.
8. Reverse the procedure for installation.Torque the
stabilizer bolts to 18.5 ft.lbs (25 Nm).
BUCK 450 SERVICE MANUAL 20.0
CHAPTER 4
CHASSIS
PAGE. 4- 7