Table 1-27 Repair Analysis Procedure (Rap) Table - Xerox DOCUPRINT N4525 Service Quick Reference Manual

Table 1-27 Repair Analysis Procedure (RAP) Table

Displayed Error
Error Code
Message
Clear Area A C1-3
Reset Tray 1
Clear Area A, B C2-2
Reset Tray 2
Paper Jam C2-3
Clear Area A
Paper Jam C3-2
Clear Areas A,B
Paper Jam C3-3
Clear Area A, B
Clear Area C C4-0
Reset Tray 4
Paper Jam C4-1
Clear Areas B,C
Paper Jam C4-2
Clear Areas A,
B, C
Fault Description
There is a paper jam between Paper Tray 1 and
the Registration Sensor.
Logic Control on the print Engine Controller Board
sensed that the Registration Sensor did not actuate
within the specified time after the Tray 1 Feed Clutch
was actuated.
There is a paper jam between Paper Tray 2 and
Take Away Roller 2 Sensor.
Logic Control on the Print Engine Contoller Board
sensed that the Take Away Roller 2 Sensor did not
actuate within the specified time after the Tray 2 Feed
Clutch was actuated.
There is a paper jam between Paper Tray 2 and
the Registration Sensor.
Logic Control on the Print Engine Controller Board
sensed that the Registration Sensor did not actuate
within the specified time after the Tray 2 Feed Clutch
was actuated.
There is a paper jam between Tray 3 and Tray 2
Take Away Sensor.
Logic Control on the Print Engine Controller Board
sensed that the Tray 2 Take Away Sensor did not
actuate within the specified time after the Tray 3 Feed
Clutch was actuated.
There is a paper jam between Tray 3 and the
Registration Sensor.
Logic Control on the Print Engine Controller Board
sensed that when paper was fed from Tray 3, the
Registration Sensor did not actuate within the
specified time after the Tray 2 Take Away Sensor
actuated.
There is a paper jam between Paper Tray 4 and
the Tray 3 Take Away Sensor.
Logic Control on the Print Engine Controller Board
sensed that when paper was fed from Tray 4, the
Tray 3 Take Away Sensor did not actuate within the
specified time after the Tray 4 Feed Clutch was
actuated.
There is a paper jam between Paper Tray 4 and
the Tray 3 Take Away Sensor.
Logic Control on the Print Engine Controller Board
sensed that when paper was fed from Tray 4, the
Tray 3 Take Away Sensor did not actuate within the
specified time after the Tray 4 Feed Clutch was
actuated.
There is a paper jam between Tray 2 Take Away
Sensor and Tray 3 Take Away Sensor.
Logic Control on the Print Engine Controller Board
sensed that when paper was fed from Tray 4, the
Tray 2 Take Away Sensor did not actuate within the
specified time after the Tray 3 Take Away Sensor was
actuated.
Volume 1 / Print Engine - Error Codes & Messages
Go To Unit/
RAP Page
No.
RAP 1-81
1-30
RAP 1-83
1-31
RAP 1-85
1-32
RAP 2-373
2-1
RAP 2-375
2-2
RAP 2-407
2-20
RAP 2-377
2-3
RAP 2-379
2-4
1-35