Xerox DOCUPRINT N4525 Service Quick Reference Manual page 60

Table 1-27 Repair Analysis Procedure (RAP) Table (cont'd.)
Displayed Error
Error Code
Message
Paper Jam E1-6
Clear Area A
Paper Jam E3-1
Clear Area A
Paper Jam E3-6
Clear Area A
Paper Jam E4-1
Clear Area A
Paper Jam E4-2
Clear Duplx Unit
Paper Jam E4-3
Clear Area A
Paper Jam E4-5
Clear Duplx Unit
Paper Jam E4-6
Clear Area A
Close Door A E5-1
Close Door B E5-2
Close Door C E6-1
Close Duplx Unit E7-3
Paper Jam E8-1
Clear Duplx Unit
1-38 DocuPrint N4525 Network Laser Printer - Service Guide
Fault Description
There is a problem at the Registration Sensor.
Paper is detected on the Registration Sensor.
There is a paper jam at the Fuser Exit Sensor.
Logic Control on the Print Engine Controller Board
sensed the Fuser Exit Sensor did not de-actuate
within the specified time after actuating.
The Fuser Exit Sensor is actuated at printer
power on.
Logic Control on the Print Engine Controller Board
sensed the Fuser Exit Sensor was on while the
printer was in standby.
There is a paper jam at the Face Up Exit Sensor.
Logic Control on the Print Engine Controller Board
sensed that during Face-Up-Mode the Face Up Exit
Sensor did not de-actuate within the specified time
after actuating.
There is a paper jam at the Duplex Exit Sensor.
Paper outputted to the Face Up Tray did not reach
the Duplex Exit Sensor within specified time.
There is a paper jam at the Face Up Exit Sensor.
Logic Control on the Print Engine Controller Board
sensed that during Duplex Mode the Face up Exit
Sensor did not de-actuate within the specified time
after actuating.
There is a problem near the Fuser Exit Sensor.
The inverted page to be stationed in the Duplex
Module did not reach the Face Up Exit Sensor within
the specified time.
There a paper jam at the Face Up Exit Sensor.
Logic Control on the Print Engine Controller Board
sensed the Face Up Exit Sensor was on while the
printer was in standby.
The Left Door (A) is open.
The Left Door (A) is closed, but Logic Control on the
Print Engine Controller Board sensed the Left Door
(A) Interlock Switch indicates the door is open.
The Left Door (B) is open.
The Left Door (B) is closed, but Logic Control on the
Print Engine Controller Board sensed the Left Door
(A) Interlock Switch is open.
Door C is sensed to be open.
Logic Control on the Print Engine Controller Board
sensed that Door C is open.
Duplex Unit is sensed to be open.
The Duplex Unit is closed, but Logic control on the
Print Engine controller board sensed that the Duplex
Interlock Switch is open.
There is a paper jam at the Duplex Exit Sensor.
Inverted Printed Page to be outputted to the Face Up
Tray did not leave the Duplex Module Exit Sensor
within the specified time.
Go To Unit/
RAP Page
No.
RAP 1-71
1-21
RAP 1-72
1-22
RAP 1-74
1-23
RAP 1-75
1-24
RAP 3-509
3-1
RAP 1-76
1-25
RAP 1-77
1-26
RAP 1-78
1-27
RAP 1-79
1-28
RAP 1-80
1-29
RAP 2-393
2-12
RAP 3-511
3-2
RAP 3-512
3-3