Xerox DOCUPRINT N4525 Service Quick Reference Manual page 59

Table 1-27 Repair Analysis Procedure (RAP) Table (cont'd.)
Displayed Error
Error Code
Message
Paper Jam C8-3
Clear Areas B,C
Paper Jam C8-4
Clear Area C
Clear Area C C8-5
Reset Tray 5
Paper Jam C8-6
Clear Duplx Unit
Paper Jam C9-1
Reset
ENV/Bypass
Paper Jam C9-2
Reset
ENV/Bypass
Paper Jam C9-3
Reset
ENV/Bypass
Paper Jam E1-1
Clear Area A
Paper Jam E1-2
Clear Area A
Paper Jam E1-3
Clear Area A
Fault Description
There is a problem with the Tray 3 Take Away
Sensor.
Logic Control on the Print Engine Controller Board
sensed the Tray 3 Take Away Sensor was on while
the printer was in standby.
There is a problem with the Tray 4 Take Away
Sensor.
Logic Control on the Print Engine Controller Board
sensed the Tray 4 Take Away Sensor was on while
the printer was in standby.
Logic Control on the Print Engine Controller Board
sensed paper remaining at the Take-Away Roller 5
Sensor.
There is a paper jam at the Duplex Exit Sensor.
Remaining paper detected in the Duplex Module.
There is a paper jam between the Envelope Tray
and the Envelope Feed Sensor.
Paper fed from the MBF or the Envelope Feeder did
not reach the MBF/Envelope Feeder Exit Sensor
within specified time.
There a paper jam between the Multi-sheet
Bypass Feeder (MBF) and Tray 2 Take Away
Sensor.
Logic Control on the Print Engine Controller Board
sensed that when paper was fed from the Multi-sheet
Bypeas Feeder, Tray 2 Take Away Sensor did not
actuate within the specified time after the MBF Feed
Clutch was acuated.
There is a paper jam between the Multi-sheet
Bypass Feeder (MBF) and the Registration
Sensor.
Logic Control on the Print Engine Controller Board
sensed that when paper was fed from the Multi-sheet
Bypass Feeder, the Registration Sensor did not
actuate within the specified time after the MBF Feed
Clutch was actuated.
There is a paper jam at the Registration Sensor.
Logic Control on the Print Engine Controller Board
sensed the paper did not leave the Registration
Sensor within the specified time since paper feed.
There is a paper jam between the Registration
Sensor and the Fuser Exit Sensor.
Logic Control on the Print Engine Controller Board
sensed the Fuser Exit Sensor was not actuated
within the specified time since the Registration
Clutch was actuated.
There is a paper jam between the Fuser Exit
Sensor and the Face Up Exit Sensor.
Logic Control on the Print Engine Controller Board
sensed the Face Up Exit Sensor was not actuated
within the specified time since the Fuser Exit Sensor
was actuated.
Volume 1 / Print Engine - Error Codes & Messages
Go To Unit/
RAP Page
No.
RAP 2-391
2-10
RAP 2-392
2-11
RAP 2-411
2-22
RAP 3-520
3-7
RAP 4-566
4-2
RAP 1-87
1-34 4-566
RAP
4-3
RAP 1-89
1-35 4-571
RAP
4-4
RAP 1-64
1-18
RAP 1-66
1-19
RAP 1-69
1-20
1-37