Xerox DOCUPRINT N4525 Service Quick Reference Manual page 237

Removal
1.
Remove the Multi-sheet Bypass Feeder Assembly (RRP 1-25).
2. Remove the Rear Cover Assembly (RRP 1-5).
3.
Disconnect P/J603 and free the harness from the wire retaining wrap to
facilitate removal of the support assembly without risk to the wires.
4.
Remove the four machine screws securing the Multi-sheet Bypass Feeder
Support Assembly to the printer frame, and remove the Assembly.
It is not necessary to remove the two end covers to remove the
Note
MBF Support Assembly. If you do remove the end covers, take
note of the different length of the two machine screws securing
same. The four screws securing the support assembly are longer
than the two screws securing the end covers.
Replacement
1.
Position the Multi-sheet Bypass Feeder Support Assembly a few inches from
the printer frame.
2.
Insert the wire harness into the cutout in the printer frame.
3. Slide the two positioning pins that are located at both ends of the Support
Assembly into the holes in the frame.
4.
Use the four machine screws (removed in Step 4 above) to secure the
Assembly to the frame.
5.
Reconnect J603.
6.
Reinstall the Rear Cover Assembly (RRP 1-5).
7.
Reinstall the Multi-sheet Bypass Feeder Assembly (RRP 1-25).
Volume 1 / Print Engine - FRU RRPs 1-215