EDER ALGEMA-FITZEL BLITZLADER 2 Operating Instructions Manual page 88

7 Additional
Error
Warning tone
sounds when the
parking brake is
released
Service lamp on the
touch panel lights up
in conjunction with
the "Left side" or
"Right side" display
A warning tone
sounds when the
ignition is switched
on
Manual control re-
does not act
Radio remote control
does not respond
88/ 100
Cause
Freewheel activated
Buttons on the hand
control panel and on the
radio remote control do
not react.
Plateau is not full -
constantly tilted down
Sensor tilt scissors
closed does not
respond although the
plateau is completely
tilted down
Air pressure in the air
suspension too low
Checking the status
LED on the power unit
Set-up functions
are not switched on
Function for manual
control not selected
Status LED on power
unit lights up red
Set-up functions
are not switched on
Operating Instructions Algema Blitzlader 2 Air - Edition
Eder GmbH
Remedy
Deactivate the
freewheel on the cable
winch.
Use the enclosed cable
remote control of the
cable winch as an
emergency operation.
Tilt the plateau
completely until the tilt
scissors have passed
the dead centre.
Check the setting,
control LEDs on the
sensor must light up
when the plateau is
completely tilted
down.
Check air pressure and
check if necessary
Status LED no. 10
must be green; if
necessary, contact the
specialist workshop.
Switching on the set-
up functions on the
touch panel
Activate the hand
control function on the
touch panel.
Status LED no. 08
must be green, if
necessary contact the
specialist workshop.
Switching on the set-
up functions on the
touch panel
Chapter
Operating instructions
for the cable winch
see "Emergency
operation winch", page
53
see "Tilt plateau
operation ", page
21
see pictures below
Sensors
see "Air suspension",
page 65
see "Power unit", page
75
see "Tilt plateau
operation ", page
21
see "Tilt plateau
operation ", page
21
see "Power unit", page
75
see "Tilt plateau
operation ", page
21